Heavy-gauge vapor barriers, sealed foundation vents, and a dedicated sump discharge line so your Lakewood, IL crawl space stops feeding moisture into the floor joists above it.
Lakewood, IL crawl spaces vary a lot in how they were originally built, and a liner that's correct for one home can be undersized for another depending on foot traffic and storage use. We size thickness to how the space is actually used.
We follow manufacturer specs on liner overlap and seam tape so the barrier actually holds up over time.
Our technicians carry encapsulation materials on the truck for most standard-size crawl spaces, cutting down on return visits.
No hourly billing — the number we quote is the number on the final invoice.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
Every Lakewood, IL Crawl Space Encapsulation job starts with an inspection, not a generic package — here's what that typically includes.
Extraction equipment includes submersible pumps sized for tight crawl space access points.
We install heavy-duty liner rated for crawl space conditions, sealed at every seam and pier to stop ground moisture from reaching the floor joists.
Open foundation vents pull in humid outside air, which is often the real driver of Lakewood, IL crawl space condensation — we seal them as part of encapsulation.
We route discharge lines well away from the foundation so pumped water doesn't just cycle back in.
Exposed ductwork inside an unencapsulated crawl space collects condensation, which we address by insulating and sealing ducts while the space is open.
We ask about standing water, musty odor, and vent condition to gauge scope before scheduling the inspection.
A technician physically enters the space to check for standing water, existing liner condition, vent count, and duct exposure.
You'll see square footage, liner grade, vent sealing, and dehumidifier specs broken out in the written estimate.
We re-test humidity after installation to confirm the space is holding at a healthy level before we consider the job done.
"Found out our old vapor barrier had huge gaps at every seam. They redid it properly and sealed the vents too."
— Lakewood Homeowner
"Sump discharge from the old system was dumping water right back next to the foundation. They rerouted it and the crawl space finally dried out."
— Lakewood Customer
"They caught duct condensation we didn't even know was happening down there. Sealed everything up during the same visit."
— Lakewood Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Lakewood Customer
A vapor barrier is just the liner on the ground; full encapsulation seals vents, walls, and often adds a dehumidifier for complete moisture control.
Most residential spaces do well with a 12-15 mil liner; spaces used for storage or with foot traffic often need 20 mil for durability.
Some jurisdictions have code requirements around vent sealing, which we'll flag during the inspection if relevant.
If the smell persists after encapsulation, that usually points to a separate moisture source we'd need to investigate.
Yes — we extract existing water first, then proceed with liner and vent sealing once the space is dry enough to work safely.
Most residential jobs finish in one to two days depending on square footage and how much prep work is needed.
We encapsulate crawl spaces throughout Lakewood and the surrounding Lakewood, IL service area, including the zip codes listed below.
Zip codes we serve in Lakewood, IL: 60014 60098
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
